Connect to the micro usb adapter as we do not support the larger one yet.Ģ.
#Hyperterm 6.4 driver#
To start the audio system, you'll need to execute the I2C driver and pmic_tw4030_cfg utility first
#Hyperterm 6.4 drivers#
To use the drivers in the target hardware, you'll need to uncomment them in your buildfile, rebuild the image, and load the image into the board. Some of the drivers are commented out in the default buildfile. The following tables summarize the commands to launch the various drivers. The IPL and OneNAND driver development is still ongoing and that is the reason why the board cannot be booted from OneNand yet. ls).įlashing the IPL on to the target Not supported yet Now you can test the OS, simply by executing any shell builtin command or any command residing within the OS image (e.g. Starting USB EHCI Host and OTG host driver. Target=0 lun=0 Direct-Access(0) - ram Rev:įormat complete: FAT12 (4096-byte clusters), 8168 kB available. Starting on-board ethernet with TCP/IP stack. Welcome to QNX Neutrino trunk on the Texas Instruments OMAP3530 (ARMv7 Cortex-A8 core) - IGEP v2 You should see output on your terminal console, similar to the following:
Setting up the environment For OMAP3530 IGEPv2 BoardĪpply power to the target board. On your host machine, start your favorite terminal program with these settings: Step 3: Transfer the OS image to the target using the ROM monitor
#Hyperterm 6.4 code#
You can build a BSP OS image from the source code or the binary components contained in a BSP package.įor instructions about building a BSP OS image, please refer to the chapter Working with a BSP in the Building Embedded Systems manual.
#Hyperterm 6.4 serial#
If you have a Neutrino host with a serial mouse, you may have to move the mouse to the second serial port on your host, because some terminal programs require the first serial port.Connect the serial cable to the serial port on OMAP3530 IGEPv2 Board to the first serial port of your host machine (e.g.Getting Started Step 1: Connect your hardware The interrupt vector table can be found in the buildfile located at src/hardware/startup/boards/omap3530/ The tables below depict the memory layout for the image and for the flash. Terminal emulation program (Qtalk, Momentics IDE Terminal, tip, HyperTerminal, etc.).Expansion connector with access LCD lines.Expansion connector with I/O, SPI, UART.Stereo audio in and out for a microphone and headphones or speakers.DVI-D for connecting digital computer monitors.Integrated antenna and connector for external antenna.Ethernet 10/100 Mb BaseT (SMSC LAN9221i).Numonyx 4Gb NAND/ 4Gb Mobile Low Power DDR SDRAM 200 Mhz (Package on Package - PoP technology).TI OMAP3530: ARM CORTEX A8 core + POWERVR SGX 530 core + IVA2.2 + DSP TMS320C64x+.ROM Monitor version: Texas Instruments X-Loader 1.4.2, U-Boot 2009.08-0-dirty.IGEP Support site (Mostly about linux.).The expansion connector is compatible with the BeagleBoard.Ī list of differences/similarities between the IGEPv2 and BB platform can be found in the IGEPv2 Hardware (revision IGEPv2-RB1) list. ethernet connector, wifi, bluetooth and RS485. The IGEPv2 is a Spanish BeagleBoard clone, slightly larger and with additional peripherals like e.g. Release Notes for the QNX Neutrino 6.4.1 BSP for OMAP3530 IGEPv2 Board Introduction
0 kommentar(er)
